PolyPipe to Copper conection?

[dylanh]

Hi,

Can anyone tell me about making a connection between Copper pipe & PolyPipe, is it just the same principle as making a PolyPipe on PolyPipe connection i.e. you just push both ends into a standard straight coupler, or do you have to get a special coupler or replace any parts inside one with a brass olive or something??

Cheers

 

[EliteHeat]

Just push it on, no other bits required.

 

[dylanh]

Excellent, it's always good to check

 

[WelshMan]

Just make sure you deburr the end of the copper pipe and there are no rough sharp edges. Failure to do this could result in slicing thorugh the o ring inside the fitting.