Hi all,
When i run the HW tap there is a red light that comes on inside and the boiler fires up and i have hot water so i presume all pumps etc are working fine.
However... When i push the swith to turn on the CH, whether on constant or timer i get absolutly nothing...no red light, firing or anything.
The boiler sems to over run for about 10 -15 seconds after water is switched off but then goes off.
If anyone can help me i would be very grateful, i know very little about boilers so step by step in laymans terms would really help.
thanks in anticipation
Allison
When i run the HW tap there is a red light that comes on inside and the boiler fires up and i have hot water so i presume all pumps etc are working fine.
However... When i push the swith to turn on the CH, whether on constant or timer i get absolutly nothing...no red light, firing or anything.
The boiler sems to over run for about 10 -15 seconds after water is switched off but then goes off.
If anyone can help me i would be very grateful, i know very little about boilers so step by step in laymans terms would really help.
thanks in anticipation
Allison