Potterton EP2000 wiring query re:connections

[rhbmcse]

Hi,
I have found a similar question but no answer, so my question is this - I hope simple to a person in the know!

I am replacing my EP2000 (very old) programmer to a new location only 1 metre from it's current location with a Drayton Tempus 7 unit.

I'm very DIY savvy but my existing wiring has no connection to pin 2 inside the EP2000 which is CH off. Everything else I understand.

When I wire in the new Tempus 7 will it require a connection to pin 2 for CH off (wiring is identical for both old and new units).

In addition to this - for extending the cables, what Amp rating cable should I use?

Any help appreciated greatly.

Rob.

 

[Rob]

Just wire it in as the old one. Its for an older style motor valve, yours presumably are spring return.

also rob

 

[rhbmcse]

Rob,
thank you very much for your assistance.
Any suggestions as to the type/amps of cable used to extend the existing wiring?

Thanks again.

Rob.

 

[corgiman]

dont start another thread u nawty boy

 

[rhbmcse]

Sorree!

 

[gas4you]

Rob,
thank you very much for your assistance.
Any suggestions as to the type/amps of cable used to extend the existing wiring?

Thanks again.

Rob.

0.75mm2 flex, heat resistant if near heat source