Hi
I switched off the water at the stopcock to change a kitchen mixer tap, i also turned the taps on the filling loop to try and isolate the boiler as recommended by tap instructions. When i turned the water back on at the stop cock no hot water comes out of any hot tap in the house. heating works fine.
I did inadvertantly pressurise the heating system to about 3 bar by leaving the filling loop open! I've drained the heating system and the pressure is back on 1.
When i turn on hot tap a little dribble of cold runs out or a few seconds and then stops.
Any ideas what's wrong? Any help appreciated.
Many thanks,
Gareth
I switched off the water at the stopcock to change a kitchen mixer tap, i also turned the taps on the filling loop to try and isolate the boiler as recommended by tap instructions. When i turned the water back on at the stop cock no hot water comes out of any hot tap in the house. heating works fine.
I did inadvertantly pressurise the heating system to about 3 bar by leaving the filling loop open! I've drained the heating system and the pressure is back on 1.
When i turn on hot tap a little dribble of cold runs out or a few seconds and then stops.
Any ideas what's wrong? Any help appreciated.
Many thanks,
Gareth