Some pics from my power to the shed project. Wiring up the shed first before the SWA is run to the shed from the house (20m).
Earthing T-N-C-S (PME).
Shed CU = 40A 30mA RCD.
1x 20A MCB for 2x 2g sockets. Not anticipating any more load than this.
1x 6A MCB for a 80W light.
Cabling is all done with singles ran in 20mm conduit. 2.5mm singles ran as radials for the sockets and 1.5mm single ran for the lights. As part of the set up, a connection will be available for decking lights plugged into a socket via a junction box with a 1A in-line fuse where the circuit shall leave the shed via ducting.
Got the consumer unit in place but not got it wired up yet as still to do the various tests, such as insulation and continuity.
Earthing T-N-C-S (PME).
Shed CU = 40A 30mA RCD.
1x 20A MCB for 2x 2g sockets. Not anticipating any more load than this.
1x 6A MCB for a 80W light.
Cabling is all done with singles ran in 20mm conduit. 2.5mm singles ran as radials for the sockets and 1.5mm single ran for the lights. As part of the set up, a connection will be available for decking lights plugged into a socket via a junction box with a 1A in-line fuse where the circuit shall leave the shed via ducting.
Got the consumer unit in place but not got it wired up yet as still to do the various tests, such as insulation and continuity.