Hello
On our mains inlet supply we have a PRV with a mechanical guage attached. The red line was set to 2 bars and it usually registered a pressure of 4 bars. Over the last week this has gone down to 2 - 2.5 bars. But we have noticed no change in our water pressure from the taps, and our boiler and heating and all water reliant appliances work fine. The guage is on the OUTLET side, so registers the water pressure once it has been through the PRV.
Does this sound like a faulty guage? Any advice much appreciated.
On our mains inlet supply we have a PRV with a mechanical guage attached. The red line was set to 2 bars and it usually registered a pressure of 4 bars. Over the last week this has gone down to 2 - 2.5 bars. But we have noticed no change in our water pressure from the taps, and our boiler and heating and all water reliant appliances work fine. The guage is on the OUTLET side, so registers the water pressure once it has been through the PRV.
Does this sound like a faulty guage? Any advice much appreciated.
