Hi,
We bought our first house with Pyronix Sterling10 installed a year ago, we did not used the alarm initially but then configured it to chime & fire alert mode, yesterday when we came back from office the main unit was sounding after every 4-5 seconds and there was no power/display on the key pad.
#1) I switched mains power off, took the fuse off and then opened the main unit of the alarm system. I didn't realised about the tamper alarm and it started sounding.
#2) I took off "2A battery fuse" on the PCB board the bell outside started sounding, i plugged the fuse back in which resulted in the outside bell not sounding as well as the tamper alarm was not sounding.
#3) I then checked the "1 AMP AUX" which was blown, i replaced that fuse with 1 AMP fuse from B&Q & screwed the main panel cover in. But there is still now power/display on keypad.
What am I doing wrong? really need you help/advice.
We bought our first house with Pyronix Sterling10 installed a year ago, we did not used the alarm initially but then configured it to chime & fire alert mode, yesterday when we came back from office the main unit was sounding after every 4-5 seconds and there was no power/display on the key pad.
#1) I switched mains power off, took the fuse off and then opened the main unit of the alarm system. I didn't realised about the tamper alarm and it started sounding.
#2) I took off "2A battery fuse" on the PCB board the bell outside started sounding, i plugged the fuse back in which resulted in the outside bell not sounding as well as the tamper alarm was not sounding.
#3) I then checked the "1 AMP AUX" which was blown, i replaced that fuse with 1 AMP fuse from B&Q & screwed the main panel cover in. But there is still now power/display on keypad.
What am I doing wrong? really need you help/advice.