My ravenheat CSI 85T (LPG) combi cuts out continuously when the gas pressure at the burner is set to above 28 mbar. When below 28 mbar at the burner, the boiler runs ok, but the DHW performance is poor.
According to the Ravenheat manual, there should be 37 mbar at the inlet and 35.4 mbar at the burner (propane versions). I have 37mbar inlet pressure, but cannot go beyond 28 mbar at the burner without this problems appearing.
The boiler is less than 6 months old. Any ideas?
According to the Ravenheat manual, there should be 37 mbar at the inlet and 35.4 mbar at the burner (propane versions). I have 37mbar inlet pressure, but cannot go beyond 28 mbar at the burner without this problems appearing.
The boiler is less than 6 months old. Any ideas?
