A slug got into the control module of my WMUD962 Hotpoint Ultima and fried some circuits while on timer/standby.
Just got a recon from EMW.
Fitted it.
Turns on ok, then I start a wash it goes on/off/on/off etc with the water intake then the display goes off.
Then I turn the power off at the mains and the display lights up with 'power on'!
I'm assuming that the replacement module is probably bobbins?
Since the washer was in standby when the module originally fried (and tripped the consumer unit), I wouldn't think that anything else would be at fault within the machine?
My wife is near meltdown over this.
Just got a recon from EMW.
Fitted it.
Turns on ok, then I start a wash it goes on/off/on/off etc with the water intake then the display goes off.
Then I turn the power off at the mains and the display lights up with 'power on'!
I'm assuming that the replacement module is probably bobbins?
Since the washer was in standby when the module originally fried (and tripped the consumer unit), I wouldn't think that anything else would be at fault within the machine?
My wife is near meltdown over this.