I have removed some oak beading to replace solid panels with glass, marked the beading as I removed it but it will not go back in, any suggestions please?
Reinstalling Oak Beading
- Thread starter ntman2000
- Start date
Sponsored Links
It just probably needs springing back into place.
I'm guessing that it seems to be a few millimetres too long?
By putting the one end in and bowing with little pressure at the middle of the lenght in towards the center of the panel the beading should fit into place. The beading should be fitted so that it just catches into the rebate which will allow easier fitting and finally tapped home with a piece of scrap and a hammer. Hope this is clear and helpful.
I'm guessing that it seems to be a few millimetres too long?
By putting the one end in and bowing with little pressure at the middle of the lenght in towards the center of the panel the beading should fit into place. The beading should be fitted so that it just catches into the rebate which will allow easier fitting and finally tapped home with a piece of scrap and a hammer. Hope this is clear and helpful.
Sponsored Links
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
