The pilot light is lit and always has been, problem is when turning the
Removed radiator niw no hot water or heating?
- Thread starter notnochippy
- Start date
Sponsored Links
Room stat, boiler does nothing and still no hot water
And pump still ok
Now no water from hot tap?
Sponsored Links
That would provide a quick way for hot water to return to the boiler without passing through any radiators, so I'm not surprised to hear that other radiators don't heat up. Is this bathroom radiator relatively close to the boiler? Maybe all the hot water is going that way and the boiler thermostat is turning it off.
I presume you did that because you didn't have the right fittings to cap off the siezed valves. If you're going to replace the valves with ones that aren't jammed up, do that now, turn them off, and then remove your temporary connection - and see what happens.
Thanks for your reply, already put a new rad on but nothing is working but even got any running water through hit tap now. I am convinced there must be some sludge blocking the system. Another thing is , when I drained the system 2 out of 3 ground floor rads would not drain and also have no air in them when I bleed?
No water comes out of the hot tap?!
You have a hot water cylinder, right?
Did you turn a valve off and then forget to turn it back on again?
Valve is on
Is it possible you have turned off a mains water feed to the header/f&e tanks?
No all is on, water coming from hot water tap now , still not heating up
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Sponsored Links
