Hi
I am replacing a Danfoss RX1 wireless stat receiver with a Hive V2. My system has the following components
Honeywell Programmer near the boiler
RX1 near the wiring center
Honeywell Wiring Center
The backplate of the programmer looks compatible with the Hive receiver so just planning to swap that out as the wiring diagrams for both are the same.
My question is concerning what to do the with the RX1 stat receiver. It's connected into my wiring center as pictured. Is it ok to just remove this or do I need to link any of the pins?
Configured our side and provide to BT
I am replacing a Danfoss RX1 wireless stat receiver with a Hive V2. My system has the following components
Honeywell Programmer near the boiler
RX1 near the wiring center
Honeywell Wiring Center
The backplate of the programmer looks compatible with the Hive receiver so just planning to swap that out as the wiring diagrams for both are the same.
My question is concerning what to do the with the RX1 stat receiver. It's connected into my wiring center as pictured. Is it ok to just remove this or do I need to link any of the pins?
Configured our side and provide to BT