Replacing Danfoss RX2C with HIVE?

[Nickpor]

Hi

I have an outside condensing combi oil boiler 'Worcester Greenstar heatslave External 18/25'. There is no hot water tank just hot water on demand.

I have 2 x Danfoss TP 5000 Si RF remotes that control 2 heating zones. They RF connect to a Danfoss RX2C located on the wall in a walk in cupboard in bedroom.

I am looking to be able to use Hive (or any better Wifi suggestions) for to replace the RX2C. Is this possible as Hive said they are not sure!

I have seen a thread on here with the single zone RX1 being changed for HIVE and all seemed OK.

Wiring and back of Danfoss RX2C above.

Any comments greatly appreciated!

Thanks

​

 

[Mitch8726]

Hi did you manage to get your HIVE wired up? How did you do it if you don’t mind me asking as I have the same system