Router & table set up before my work starts.

[ipbr21054]

Hi,
Just purchased a like new condition Makita router table & now fitting the router to it.
My question is, do I just clamp the router flange to the underside of the table using the 4 knobs or must I put some kind of screw down through table surface and secure it into the router flange.

 

[big-all]

havent got a clue about the makita
but normally gravity and a rebate hold the router and base its fixed to in place

 

[ipbr21054]

Hi,
The router is fixed from under the table.
The hole is say 2 inches and just for the bit to pass through.

It isn’t placed through the table top and then sits on an edge.

 

[big-all]

it will tend to be with the fixings supplied from underneath
what model is the router table ??

 

[ipbr21054]

Hi,
I have now used fixings and also screwed from the top.
Thanks for the info