Scantrinic 9450 - how to reprogram out an int. door

[theelliotts]

Hi,

I have a scantronic 9450 alarm and recently an internal door was replaced and the 'pad' on top of the door went with the old door.

Now I cant set the alarm and I think this is the problem.

How can I remove this from the system?

I have printed the Installation and user guide from the internet but still not sure.

Any help / advice would be appreciated!

Margaret

 

[joe-90]

You can either put a new magnet on the new door or undo the contact and twist the two wires that go to the silver terminals together and the two wires that go to the brass terminal together and then keep them apart, Then try it.