Scantronic 9448+ alarm reset needed?

Can anyone tell me how to reset an alarm code on a scantronic 9448+ as the alarm went off after a power cut and the code doesnt work. I am not sure if it is the correct code therefore I think it needs a full reset??

 

It may have locked out due to faulty battery ..... Step one down power mains and battery .... Re power up mains only.... Enter the code you think it may be...if this does not work enter 1234 does it stop ? Yes ? It may have defaulted check all zones , it may need reprogramming....step 2 the code didn't stop it ! Power down again and repower up with the NVM link on the main panel shorted , remove link and enter 1234 does it stop ? Yes right reprogram system and replace battery ...

 

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.

Please select a service and enter a location to continue...

Plumber / Gas Engineer Electrician Builder Decorator Builders' Merchant Plumbers' Merchant Tile Supplier Flooring Supplier
Start Search

Are you a trade or supplier? You can create your listing free at DIYnot Local