hi
i have just purchased and fitted an old scantronic 9450 panel for my shed with a couple of probems.
i have conected one door sensor to ee and one to zone 2. all others are looped out but when i try to set the alarm the tamper fault lights up. can anybody give me a clue what might be causing this?
also the bell supplied which was aparently connected before the system was stripped out is a bell with only 2 connections. can you confirm what these should be connected to? i have them connected to BELL and +12v which is working.
i am guessing that there shoud be a tamper for the bell looped out but what should i connect?
any help would be greatly appreciated
steve
i have just purchased and fitted an old scantronic 9450 panel for my shed with a couple of probems.
i have conected one door sensor to ee and one to zone 2. all others are looped out but when i try to set the alarm the tamper fault lights up. can anybody give me a clue what might be causing this?
also the bell supplied which was aparently connected before the system was stripped out is a bell with only 2 connections. can you confirm what these should be connected to? i have them connected to BELL and +12v which is working.
i am guessing that there shoud be a tamper for the bell looped out but what should i connect?
any help would be greatly appreciated
steve