Hi all,
I want to reduce condensation in the attic and therefore cut off the supply of moist air as much as possible.
I have lights that are flush to the ceiling, some radiator pipes going up through external trunking, and in the boiler cupboard a load of pipes just punched through the plaster with big holes around them.
I'm thinking to use CT1 to seal holes. Is it best to do this from the attic side or the ceiling side? Also, any suggestions for the boiler cupboard ceiling with the bigger holes? Hard to put a board up as there are quite a few pipes in different positions. How about foil tape around them plus some sealant?
Thanks
I want to reduce condensation in the attic and therefore cut off the supply of moist air as much as possible.
I have lights that are flush to the ceiling, some radiator pipes going up through external trunking, and in the boiler cupboard a load of pipes just punched through the plaster with big holes around them.
I'm thinking to use CT1 to seal holes. Is it best to do this from the attic side or the ceiling side? Also, any suggestions for the boiler cupboard ceiling with the bigger holes? Hard to put a board up as there are quite a few pipes in different positions. How about foil tape around them plus some sealant?
Thanks