I've got one of these drills & had to fit a new trigger switch. Done that bit fine, but when I was finding how to take it apart I also opened the gearbox. Now I can't get the 'mode' switch back in properly. I can see how the pin (no46) goes into the spring (no45) to work the mech. But I can't get it to locate when I put the thing together.
Oh, the diagram the numbers are for is http://www.powertoolspares.com/tool...r-rotary-hammer-pbh-220-re/0603336742/spares/
Does anyone know how to do this as I can't find a service manual for this drill.
Oh, the diagram the numbers are for is http://www.powertoolspares.com/tool...r-rotary-hammer-pbh-220-re/0603336742/spares/
Does anyone know how to do this as I can't find a service manual for this drill.