Shaver socket/underfloor heating quick Q

[bigstevex]

I was going to finish this of this evening if someone could just confirm its ok?

4.0mm into the 2 spurs then 1.5mm from the fused spurs to the accessories and change the 16A mcb to a 10A mcb?

 

[securespark]

What do the mfrs of the equipment you wish to install demand?

 

[bigstevex]

the shaver socket is 3A but through an rcd which is it on the cu!

the u/f heating is 30ma rcd (at cu again) and 2.4 amp draw at most i think! hence the 3A fuse, if i'm wrong though and it is 5A 1.5mm is still easily capable! I don't have the instructions to hand at the moment to double check sorry!

 

[bongos]

the shaver socket is 3A but through an rcd which is it on the cu!

the u/f heating is 30ma rcd (at cu again) and 2.4 amp draw at most i think! hence the 3A fuse, if i'm wrong though and it is 5A 1.5mm is still easily capable!

The MI should be followed. As long as you have all that is required of them then your plan sounds ok.

 

[ban-all-sheds]

Lol, this is getting very conflicting/confusing now....

http://www.tlc-direct.co.uk/Book/4.3.1.htm