Hi, I have purchased an ex display kitchen which inlcuded Silestone worktops. One run has the sink and hob cutout already done, I have another piece which will sit on top of some units but with no cuts required at all. I want to purchase a further piece which will only have a 90 degree cut out to fit round a pipechase in the corner of the wall.
My question is can my kitchen fitter refit these - he is very experienced and an excellent tradesman. the suppliers of these products keep insisting you need their specialist to fit them - is this another case where you get ripped off because you are scared to have someone else do it incase something goes wrong. Also, I have just run off a manual on the internet which is used for training purposes for new fitters - this goes through everything you need to do to fit the tops.
Any help would be appreciated.
jeanjeanie
My question is can my kitchen fitter refit these - he is very experienced and an excellent tradesman. the suppliers of these products keep insisting you need their specialist to fit them - is this another case where you get ripped off because you are scared to have someone else do it incase something goes wrong. Also, I have just run off a manual on the internet which is used for training purposes for new fitters - this goes through everything you need to do to fit the tops.
Any help would be appreciated.
jeanjeanie