Solder joints, im quite happy to solder bends onto new pipe however when your working on an old pipe thats had water in it never works. As you can never drain every drip of water out of the pipes, when you try to solder the water is drawn to the heat and the solder will not run as the pipe doesn't get hot enough. Whats the trick other then using a compression gland / plastic push fit.
Solder Joints
- Thread starter fattony
- Start date
Sponsored Links
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Sponsored Links
