Hi One of my low voltage spot lights blew.When I went to replace it found that the block connector had melted and also that the transformer was U/S.Got a replacement 12v 50va transformer replacement and rewired up
bulb (12v 50w).The light works fine but after a while the light goes off I
think the transformer thermo switch is tripping cooling and then light comes back on.The other 2 spots lights are fine.Would reducing the bulb down to 12v 20w cure this as transformer said 50w bulb was max or is their an electrical problem???
bulb (12v 50w).The light works fine but after a while the light goes off I
think the transformer thermo switch is tripping cooling and then light comes back on.The other 2 spots lights are fine.Would reducing the bulb down to 12v 20w cure this as transformer said 50w bulb was max or is their an electrical problem???