Hi all again......
Thanks for all previous advice.
Following a bit of a reconfiguration of pipework......
Great advice from here. Heating has been far better ......then......
Noticed a quiet tinkling rattling sound.
After pressing my ear to one of the actuators, I believe it is coming from there.
It is a Sunvic SM5203 MoMo actuator on an EML3454 body.
Then I noticed......When I repiped, I have put it in the system with the "flow" arrow in the wong direction.
So......Has anybody any experience of this? Does it matter? Will I have caused any lasting damage?
Is that what is likely to be causing the rattle sound?
Any idea what is in the body that causes the rattle?
Just wanted to have somebody confirm this can cause noise before I drain down / turn it round.
Cheers.
Ian.
Thanks for all previous advice.
Following a bit of a reconfiguration of pipework......
Great advice from here. Heating has been far better ......then......
Noticed a quiet tinkling rattling sound.
After pressing my ear to one of the actuators, I believe it is coming from there.
It is a Sunvic SM5203 MoMo actuator on an EML3454 body.
Then I noticed......When I repiped, I have put it in the system with the "flow" arrow in the wong direction.
So......Has anybody any experience of this? Does it matter? Will I have caused any lasting damage?
Is that what is likely to be causing the rattle sound?
Any idea what is in the body that causes the rattle?
Just wanted to have somebody confirm this can cause noise before I drain down / turn it round.
Cheers.
Ian.
