Hi again. Just to refresh your memories. I installed a new wall switch for my washing machine and the litle red light on the switch that indicates if it is on stays on continually whether the switch is on or not. A few people told me (which i am very grateful for) that it was load and feed the wrong way round so i swapped them and it is still the same. I have the switched wired up as follows. LOAD -N - 2 BLACK WIRES, LOAD -L- 2 RED WIRES,
FEED - L - 1 RED WIRE, FEED - N - 1 BLACK WIRE, AND TWO SEPERATE EARTH WIRES INTO SEPERATES SCREWHOLDESR. Is this right? Any help appreciated again folks.
Ps thanks again for all previous help
FEED - L - 1 RED WIRE, FEED - N - 1 BLACK WIRE, AND TWO SEPERATE EARTH WIRES INTO SEPERATES SCREWHOLDESR. Is this right? Any help appreciated again folks.
Ps thanks again for all previous help