Anyone know who sells 22mm x 1/2" bsp bent tap connectors, it's for fitting a rainfall shower head and the manual says to use 22mm pipe where possible. I could reduce down to 15mm and use a 15mm bent tap connector but thought this would cause a restriction and reduce the flow.
-
Looking for a smarter way to manage your heating this winter? We’ve been testing the new Aqara Radiator Thermostat W600 to see how quiet, accurate and easy it is to use around the home. Click here read our review.
Tap connector
- Thread starter Shift
- Start date
can you gain access to the rear of the shower head when fitted ?
I can at the moment but obviously wont be able to when plasterboard and tiles are fitted.
you can't fit the shower head etc until tiled and finished.
Not fitted permantly at the moment, I've fitted a joist at the shower head height and grafted in a piece of aluminium for strength then I mocked up the thickness of plasterboard and tiles using a piece of wood. The outside of the stud wall will not be plasterboarded until the inside is finished and shower head fitted.
so you can get rear access to fit shower head after tiling etc, then fit plasterboard to other side.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Similar threads
