Hi,
I have a Jaguar 23 combi boiler (from wicks i think) and i've just had a bristan tulsa therm shower installed to replace the electric one. The cold water is mains fed and the pressure and hot water temp of the bath underneath is really good.
The problem is that after a few minutes the force of the flow slows down almost to a trickle.
the flow rate of the hot water from the combi is supposed to be 11.2 at 30 and 9.6 at 35 degrees which i think should be good enough for the shower.
the boiler is about 7 years old and about 2 meters away from the shower. the flat is two bedroom with 5 radiators.
any ideas what is causing this?
I have a Jaguar 23 combi boiler (from wicks i think) and i've just had a bristan tulsa therm shower installed to replace the electric one. The cold water is mains fed and the pressure and hot water temp of the bath underneath is really good.
The problem is that after a few minutes the force of the flow slows down almost to a trickle.
the flow rate of the hot water from the combi is supposed to be 11.2 at 30 and 9.6 at 35 degrees which i think should be good enough for the shower.
the boiler is about 7 years old and about 2 meters away from the shower. the flat is two bedroom with 5 radiators.
any ideas what is causing this?
