- Joined
- 16 Feb 2019
- Messages
- 3
- Reaction score
- 0
- Country
I have a 1/2" copper feed into a valve through a compression fitting and I need to replace the valve and subsequent copper. The nut at the entry to the valve is very close to a bulkead and while access to the nut is just possible it would be virtually impossible to cut back and change the nut and olive.
Is the thread on a new 15mm valve likely to match the one on the end of my 1/2" pipe?
If not it is likely to be hammer and chisel time, lots of work, dust, bad language and eventual making good, so I'm really hoping for some good news fellas....;o)
Thanks,
John
Is the thread on a new 15mm valve likely to match the one on the end of my 1/2" pipe?
If not it is likely to be hammer and chisel time, lots of work, dust, bad language and eventual making good, so I'm really hoping for some good news fellas....;o)
Thanks,
John