Hello Team,
I'm about to upgrade my fuseboards to split load RCD jobs.
My house is quite 'long' and has a fuseboard at the front door supplying the front house sockets/lights and a fuseboard at the back of the house in the kitchen which supplies the rear ringmain and lights.
An electrical chap suggested rewiring and installing one large split load consumer unit at the front.
Couldn't I just install two new consumer units in these original locations?
Question 2, my new oven wants 30A, is 2.5mm FT&E OK for this?
Cheers!
I'm about to upgrade my fuseboards to split load RCD jobs.
My house is quite 'long' and has a fuseboard at the front door supplying the front house sockets/lights and a fuseboard at the back of the house in the kitchen which supplies the rear ringmain and lights.
An electrical chap suggested rewiring and installing one large split load consumer unit at the front.
Couldn't I just install two new consumer units in these original locations?
Question 2, my new oven wants 30A, is 2.5mm FT&E OK for this?
Cheers!