Un-Level floor remedy?

[wombats]

I have ordered some bedroom furniture which will cover the full length of my bedroom. There are floorboards down but when measuring to mar a level line on the wall it seems that the floor is out by 15mm over 13ft. Which when putting units next to each other all the same size they are not going to sit straight.

Is there an easy way to level the floor so that they can be installed straight? They 630mm deep from wall, so i think that i would only need to level this amount ( Or do i?).

 

[mac391]

4mm per metre, pretty average . I'd just try it as it is. You could use packers underneath if not totally happy but then you'd probably notice them at the low end.

And to level the floor properly is quite a big undertaking,, i'd just put up with the 15mm.. and hang a picture at 92.3 degrees

 

[wombats]

mac391

Thanks for the reply. The only reason i am thinking it may look bad as all the units are the same size and fit alongside each other. Thinking that they may look stepped, Also 1 of them is an overbed fittament which has to be fastened to the top on either side.

 

[wombats]

Anyone else have any more help or advice?

 

[dazlight]

I levelled a living room which was running out last year. We put 6mm WBP plywood down. Nailed down with ring nails. Then primed the plywood then lay mapei renovation wood screed which is able to flex so ideal for screeding over wood. I used that to get the floor level.