Hi, I am about to tile the kitchen floor but do not have the clearance on the UPVC back door. Need about 10mm off the bottom. Can I trim this with a jigsaw? or should I try re-hanging the door higher?
Thanks
Thanks
-
Looking for a smarter way to manage your heating this winter? We’ve been testing the new Aqara Radiator Thermostat W600 to see how quiet, accurate and easy it is to use around the home. Click here read our review.
UPVS Door, need to trim the bottom
- Thread starter kippermanbike
- Start date
Id remove the door and refit higher, if its already tight to the top i'd trim 10mm of the height, 10mm is too much to lift on the hinges, assuming it has flag hinges that is, i wouldnt trim anything off the door sash itself as the rubber bubble gasket will fall out and you'll have a draught then 
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
