I am installing some velux windows in a new roof and want to fit the windows before the felt and batons so I can get a nice tight fit round the window with the felt. Normally the windows are fitted on tile batons running accros the top and bottom of the openings which are longer than the width, but I don't think this would work very well if I was felting afterwards. I think the window needs to be fixed at the same height as the top of the tile baton for the flashings to work properly, so does anyone know the best way to do this please?
-
Looking for a smarter way to manage your heating this winter? We’ve been testing the new Aqara Radiator Thermostat W600 to see how quiet, accurate and easy it is to use around the home. Click here read our review.
Velux installation in a new roof
- Thread starter pkone
- Start date
There is'nt an easy way of doing it the corner bracket's have to sit on the same height as the top of the tile batton.If your worried about the water getting in ,felt over the top of the hole and put the water tray in above the velux which catches any penatrating water from above.Then put your window in with the felt keeping the hole water tight then cut the felt out from the inside after the tilling is compete.Just keep the felt loose under the window incase the velux comes under the top face of the truss.
Thank you for your responce. I cant see anything where it says take a look, should there be a photo ar something attached?
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
