Hi from Andalucía and thanks in advance for your assistance.
I want to connect the Powermax Complete to another system where the PM is acting as a slave system.
I need to arm the system via Zone 29, witch I defined like stated in the installer manual as non-alarm zone and z-key was enabled. The resistances where set. Now the control panel should toggles between AWAY mode and Disarm. But all it's doing it says tamper open, tamper close. No arming or disarming. Any idea what I am doing wrong?
I want to connect the Powermax Complete to another system where the PM is acting as a slave system.
I need to arm the system via Zone 29, witch I defined like stated in the installer manual as non-alarm zone and z-key was enabled. The resistances where set. Now the control panel should toggles between AWAY mode and Disarm. But all it's doing it says tamper open, tamper close. No arming or disarming. Any idea what I am doing wrong?