Vokera Mynute HE

[Ciaran369]

Im in trouble and hope an expert can help me. I have moved my boiler today and i was quite impressed with how neat the plumbing turned out. I filled the system and brought the pressure up to 1 bar and bled all the rads to release any air. Checked everything for leaks etc.. Turned on the boiler and hey presto it fired up and heated the rads as planned. Went to turn it back on an hour later after cleaning up and it shows ERROR CODE 52. I have searched everywhere on the net for a solution and all i can find is Call an engineer :'( I definitely cant afford to do that as i have been unemployed for 2yrs Im used to doing a bit of plumbing in bathrooms, i was a tiler for 22yrs and nothing happening these days.
Any help would be most appreciated to help sort out my problem.

Best Regards

 

[stardanny]

Error 52 is a internal fault. Have you tried reset, if it happen then

Get a gas safe engineer, he will do a fault finding to see what the problem is.

Your moving may have done something that is affecting the boiler that should had been done by gas safe engineer. Please do not do anything till you get it check out, especially on gas side.

Daniel.

 

[Agile]

Obviously this is what can happen if you DIY a boiler installation.

At least if you had been able to have it done by an engineer then you could have blamed the fault on him.

Many of these "other" fault codes are in fact the PCB but before replacing an expensive part its necessary to fully check everything else!

For example, have you measured the polarity of the supply connections?

Tony

 

[Ciaran369]

Thanks Tony

There was a problem withe the PCB, managed to sort it out.

Thanks for your help