I have recently bought washing machine but no hot water pipe, installation guide suggest fitting 3/4" sealing cap on hot water pipe. Currenting got T - Section. Have bought 15mm compression cap from B&Q to small so tried 22mm too big. Any ideas
If the pipe supplying the hot water washing machine valve is 15mm copper, you can use the 15mm stop end. Turn off and drain the hot water from the pipe, undo the compression joint on the upstream side of the valve and then use stopper bit of the stop end in conjunction with the nut and olive left on the pipe.
If you need to find a tradesperson to get your job done, please try our local search below,
or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Please select a service and enter a location to continue...
Are you a trade or supplier? You can create your listing free at DIYnot Local