washing machine plumbing
- Thread starter Tigress
- Start date
Sponsored Links
Yes I think you mean can a washing machine with 2 valves hot and cold, be used on cold fill only. The answer is yes, but you need to provide water to BOTH valves in order for all programmes to work properly. This is done as you say with a Y piece that goes on the cold tap and then run 2 hoses from that one to each valve.
If your'e confident enough you can piggy back the switched wire that runs to the hot valve onto the switch wire that goes to the cold valve, hence the col valve is energised when hot water is requested, only 1 pipe to the cold valve would be needed in this case, but all the powder if you use drawer will have to go into the cold side compartment
If your'e confident enough you can piggy back the switched wire that runs to the hot valve onto the switch wire that goes to the cold valve, hence the col valve is energised when hot water is requested, only 1 pipe to the cold valve would be needed in this case, but all the powder if you use drawer will have to go into the cold side compartment
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Sponsored Links
