WD645A - Washer / Drier - Top and door seal

[Mel_P]

I have refitted the front door seal (with the wire / spring loop! - tricky) on my daughters washer drier but the rubber is a bit soft and I think the rubber seal may have a limited life.

I presume she pulled it off by pulling too much washing out and has used it for a while with seal only partially fixed and "folded"

I have ordered a new seal as "insurance" but have a couple of questions.

I have undone the two lid screws but am not sure to get the lid off if i "ease" it (i.e. give it a thump) at the back to nudge it forwards or at the front to nudge it backwards Advice please

Do I need to take the whole front panel off or just move the electronic panel Advice please

Thanks, Mel

 

[rocks1]

Lid slides front to back. Yes u can take front panel off poss a lot easier. Consol panel comes off and then front.