I have pressed start and when i close door it normally starts. Have tried pushing door to ensure it clicks. Is this something simple like a door switch or sensor or do i need a new dishwasher? Have read all other whirlpool commentary would appreciate comment from sleepyhead -Thanks
Whirlpool ADG 957 won't start after closing door
- Thread starter ruskyfox
- Start date
- Joined
- 2 Apr 2006
- Messages
- 1,896
- Reaction score
- 29
- Country
Similar fault on one the other day on here.
I thought it might have been the pcb but unusual fault of the door switch being unplugged. The switches themselves aren't a common failure but it's worth starting there.
I thought it might have been the pcb but unusual fault of the door switch being unplugged. The switches themselves aren't a common failure but it's worth starting there.
Thanks! I thought it was the door not fully shut initially. I have the cover off and there is a connector block going to the white door latch which i assume is what you mean. Plugged in and out a few times but no go. How much is a PCB if I need one? This machine is nearly 10 yrs old
Thks again
Thks again
- Joined
- 2 Apr 2006
- Messages
- 1,896
- Reaction score
- 29
- Country
At 10 years old I'd check the wiring in the door at the bottom, can be snapped / cut where it bends to go into the base.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
