why don't they make the bits I want?

[ColJack]

stupid manufacturers..

all i want is a 90 bend that has a nut on the one end to screw onto a waste ( plughole.. ) and a tee where the tee screws onto a waste..
don't really care what pipe connection the other end has..

is that so difficult?

 

[adlplumbing]

have u tried a hepworth v trap and work from that if have lack of space

 

[dextrous]

stupid manufacturers..

all i want is a 90 bend that has a nut on the one end to screw onto a waste ( plughole.. ) and a tee where the tee screws onto a waste..
don't really care what pipe connection the other end has..

is that so difficult?

Thought I had sourced that kit for you.

 

[ColJack]

with the output hole for the waste only about an inch below the bottom of the sink, that kit wouldn't have worked ( it's about 6 inches before you get to the top of the trap that way.. )

I've managed to bodge it to get me a working sink for now.. but I'm borrowing a core drill off my cousin tomorrow night so there will be a nice new 2 1/2 inch hole through the wall about a foot lower..

since the core drill is 2 1/2 inches and the pipe is only 40mm, any sugestions for filling the gap? spray foam? mortar? both?

 

[adlplumbing]

cement would do fine a small bag