Hello all,
I have one of these (sectional concrete garage).
SWMBO insisted that I buy one of these,
...and attach it onto aforementioned garage.
I am a bit concerned that, if loaded with washing, it may rip a hole in one of the concrete wall panels. As far as I know, the panels are cast only, with no rebar or the like within.
I was considering putting an oversized bit of ply or similar on the inside of the garage, to spread the load across a larger area of panel. Perhaps even away from the flat reverse of the panel, and across the thicker "shoulders" of the panel instead.
Any thoughts / suggestions / alternatives appreciated
TIA
I have one of these (sectional concrete garage).
SWMBO insisted that I buy one of these,
...and attach it onto aforementioned garage.
I am a bit concerned that, if loaded with washing, it may rip a hole in one of the concrete wall panels. As far as I know, the panels are cast only, with no rebar or the like within.
I was considering putting an oversized bit of ply or similar on the inside of the garage, to spread the load across a larger area of panel. Perhaps even away from the flat reverse of the panel, and across the thicker "shoulders" of the panel instead.
Any thoughts / suggestions / alternatives appreciated
TIA