Feel a right prat
Wrcester 28i junior
I removed the wires from the low pressure switch and the overheat stat
to test if the low pressure switch was blocked/faulty, and it was.
Without thinking or checking I assmed the diagram would be in the manufacturers instructions but cant find any.
So was wondering if someone could tell me where these wires go. There is 1 x link wire
3 connections on top of the pressure switch, one with some red tape on it.
2 loose wires to the rear of the boiler, one tide in a knot.
Added to this, does any one know an easy way to remove the over heat stat screws, they seem to be seized and hard to gain access.
Thanks
Wrcester 28i junior
I removed the wires from the low pressure switch and the overheat stat
to test if the low pressure switch was blocked/faulty, and it was.
Without thinking or checking I assmed the diagram would be in the manufacturers instructions but cant find any.
So was wondering if someone could tell me where these wires go. There is 1 x link wire
3 connections on top of the pressure switch, one with some red tape on it.
2 loose wires to the rear of the boiler, one tide in a knot.
Added to this, does any one know an easy way to remove the over heat stat screws, they seem to be seized and hard to gain access.
Thanks