Wiring new cooker hood to a fused spur

[xpeterpx]

Ideally a task I would do myself.
I need to wire in a new cooker hood into a fused spur in the nearby cupboard.
The hood is attached to a moulded plug.
After isolating yhe circuit Can I just cut the moulded plug off strip back the wires and connect it?
The current hood is wired in like in this picture. Just follow the same connections? Am i overthinking it??

 

[jurassic sparkk]

After isolating yhe circuit Can I just cut the moulded plug off strip back the wires and connect it?

Yes, but bear in mind it can invalidate the warranty. Make sure the correct fuse is installed too.

If it was me, I would replace the Fcu with a 13amp socket and go from there.

Do add some earth sleeving while your at it.

 

[EFLImpudence]

Can I just cut the moulded plug off strip back the wires and connect it?
The current hood is wired in like in this picture. Just follow the same connections? Am i overthinking it??

Yes to all.

 

[xpeterpx]

Thanks as always guys