Hi Guys
I have a problem with my 24CDI I am aware that there have been a number of posts in the past but they dont seem to cover my situation.
When you run the hot eater it runs hot then cold. at which point the boiler (flame) light goes out for about 20 seconds and then relights and hey presto hot water again. The problem can be solved in the short term by turning the water temp down to minimum but this is only a stop gap measure. When the temp is set higher the water seems too hot.
We have already replaced the diverter valve diaphragm so any other ideas would be most welcome.
Cheers Euan
I have a problem with my 24CDI I am aware that there have been a number of posts in the past but they dont seem to cover my situation.
When you run the hot eater it runs hot then cold. at which point the boiler (flame) light goes out for about 20 seconds and then relights and hey presto hot water again. The problem can be solved in the short term by turning the water temp down to minimum but this is only a stop gap measure. When the temp is set higher the water seems too hot.
We have already replaced the diverter valve diaphragm so any other ideas would be most welcome.
Cheers Euan