I have been out to look at a boiler that needed repressuring as there was no Dhw or Ch. What I have deduced was that the filling loop had been left connected and had been letting by resulting in Prv opening and had blown a seal on one of the microswitches.
I decided wisely to advise to leave it to a Corgi.
What puzzles me is I searched hi and low for a pressure gauge but could not find one, (it is a combi).
Anybody have any experience on these boilers and I would like to learn from this for the future.
I must add that the system looked quite old and hadn't been fitted very professionally.
I decided wisely to advise to leave it to a Corgi.
What puzzles me is I searched hi and low for a pressure gauge but could not find one, (it is a combi).
Anybody have any experience on these boilers and I would like to learn from this for the future.
I must add that the system looked quite old and hadn't been fitted very professionally.
