- Joined
- 13 Sep 2021
- Messages
- 5
- Reaction score
- 0
- Country
Hi I am looking at building a small lean to with single sheet corrugated plastic sheet. The depth of the Lean to will be a max 2.4 M, Length would be approximately 4.6M, height approx. 2.6M
One long side is to be fixed to the house. The other log side I am planning on supporting on 4" x 4" timber posts fixed at the base to concrete, with a 4" x 2" timber spanning these notched in place. The Wall plate I was going to be a 4" x 2" timber. The roof rafters I was thinking about 3" x 2" timbers @ 600m centres supported via joist hangers either end.
Being a total novice at this I was hoping someone could help with confirming if the above sounds ok or which if any needs different sizes.
Thanks for your help.
Neil
One long side is to be fixed to the house. The other log side I am planning on supporting on 4" x 4" timber posts fixed at the base to concrete, with a 4" x 2" timber spanning these notched in place. The Wall plate I was going to be a 4" x 2" timber. The roof rafters I was thinking about 3" x 2" timbers @ 600m centres supported via joist hangers either end.
Being a total novice at this I was hoping someone could help with confirming if the above sounds ok or which if any needs different sizes.
Thanks for your help.
Neil