Hello all,
Product - CDA Contemporary Conical Base Stainless Steel Kitchen Sink Mixer Tap TV11SS.
Reference the attached picture, for the life of me I cannot get this hose to successfully stay in the cradle. I’ve ensured both cradle and hose mount are clean but it keeps falling out. Very rarely it stays in but pops out when water is turned on as the hose has a bit of pressure.
Photo shows it being held in by elastic band which is the only way to keep it there.
Understand this is a real low level question but anyone has any dramas with these in the past?
Seems to me the locking mechanism is pretty non existent and the bend in the hose naturally wants to push it out.
I am resided to the fact it’s just a poor design but if anyone has any tips it would be greatly appreciated- thanks . Seems like a poor design for such an expensive tap
Product - CDA Contemporary Conical Base Stainless Steel Kitchen Sink Mixer Tap TV11SS.
Reference the attached picture, for the life of me I cannot get this hose to successfully stay in the cradle. I’ve ensured both cradle and hose mount are clean but it keeps falling out. Very rarely it stays in but pops out when water is turned on as the hose has a bit of pressure.
Photo shows it being held in by elastic band which is the only way to keep it there.
Understand this is a real low level question but anyone has any dramas with these in the past?
Seems to me the locking mechanism is pretty non existent and the bend in the hose naturally wants to push it out.
I am resided to the fact it’s just a poor design but if anyone has any tips it would be greatly appreciated- thanks . Seems like a poor design for such an expensive tap