Hi, yes that’s the one. Apologies for not mentioning it. I used to come across this often, you have the prongs of the arm from where the washer is too high. Have a look at your original photo for clarity, but I’ve added a photo. Unclip from the lugs, feed arm into lower part to move the float up and down freely and refit lugs.
Aah yes okay! Thank you, when I was putting it back i did get stuck on this part and couldn't remember which section the arms part should be on. I will adjust it tomorrow, fingers crossed it does the trick. Ill let you know! Thanks again
No problem
Hi, so i adjusted the arm and it has worked a treat, the water is now coming into the cistern just fine and it refills fine after flushing too. I have noticed that when the cistern is refilling after flushing, the valve seems to be dripping a little, I've attached a photo with an arrow pointing to where it drips. I wasnt sure if this is okay or if maybe I have made another error
It's been a while since I've worked on one, but think that may be how they work. As long as it stops after filling
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
