being a bit nosy spotted a neighbour had work done and their boiler changed from coming straight out like the one on the left of the pic to elbowing and going rather high up then bending again. I’m no expert but that kind of doesn’t look right. A gust of wind could snap that as it’s not even got any brackets to hold it. Not to mention now the boiler has to exhaust out harder going through a few bends. Wondering if this is legal and compliant.
Is this Boiler Flue compliant?
- Thread starter mderoy
- Start date
Have you fallen out with your neighbour for any reason, and feel the need to have a go at them?
The plume kit is fine, as said above, however, it looks closer than regs permit to the vent, others may disagree.
The plume kit is fine, as said above, however, it looks closer than regs permit to the vent, others may disagree.
- Joined
- 5 Nov 2024
- Messages
- 5,059
- Reaction score
- 2,392
- Country
Looks like it’s been installed to circumvent the requirements. Should be clipped as well.
Last edited:
That's the key phrase IMO - Checkout the conclusion in TB016
duplicate
- Joined
- 22 Jan 2007
- Messages
- 23,814
- Reaction score
- 3,426
- Country
He isn't though, just a simple question which has been answered.
Personally I would classify it as at risk as it's a part of the flue system that hasn't been adequately secured. It comes with a clip why didn't they fit it?
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
