Recent content by alexwight

3 holes in many posts

I'm looking to drill 3 holes in a post. 1 is directly in the end of the post, 1 is drilled on the face at 90 degrees, and another at either 30 or 45 degrees. I'm looking for a machine rather than a jig to do this job. So it needs to be able to have a rotating head from 0-90 degrees. Any ideas?

here is the details.

I have a dust extractor thats 3 phase and looking to convert it to single phase. I want to use a digital converter, but don't know where to start. Any advice is greatly appreciated. kind regards alex

sorry m8 posted in the wrong area. :?

Failing to fire up. Pump runs. I manually activated the air pressure switch and it fired up. I checked for power getting to the fan, no power. Will it be the fan or the pcb?

What are these sizes please. Seems to be confusion between engineers where i work? I,m new, so learning all the time. The fires in question are the firegem visa ect.

I,ll be buying some soonest.

Thats why i didnt take the risk, as i thought it would be a heat proof type of tubing to be used. I,ll be looking into it though.

Cheers dave, being new and not able to get hold of anyone who would know. I didnt want to take the risk of putting anything on that would possibly cause problems.

Thank you very much, i,m newly qualified and never heard of the boiler let alone seen it :lol: Just glad i was able to find the fault. thanx again m8, alex.

Is the hose from the air pressure switch to the flue made of rubber? I had one which appeared very brittle and looked like ceramic.