Ok, battery swapped and new deeper back box installed, signal strength is now 46. Thanks for your help in resolving! In fact changed the back box...
Should have said that I get as far as connecting, putting in the 6 digit key and when I do I get an error message 'please check your network...
Great, I've got firmware 4 and smartcom, what do I need to do to connect to it?
Just recommissioned, hasn't helped really with that one unit, it struggled to pick a signal up from it (it seems to be trying to connect directly...
Polling errors started about 2 months ago, working fine until then. I will order the larger unit anyway, and sightly change the position. I...
How do I run the commissioning to re-establish the mesh? I have got to buy another sensor for another door so will just swap it for a full sized...
Hi, to answer the q's.. Batteries are a year old Sensor located at the top of the door on the inside The shed is (larch lap) timber with a...
I normally connect my laptop to my Prem elite 24 by one of the comm ports inside the panel. It always seems a bit 'fragile' though and I worry...
Have had a couple of polling errors from the micro contact on the shed so had omitted from the system (the worst luck, broken into last night so...
I have a Bosch Tritech PIR (ISC-BDL2-WP12H) in a corridor which keeps false alarming (normally in the dead of night!) and I don't know why. I...
Thank you, got it. You inspired me to have a nosey round the area programming, turns out that the panel speaker wasn't attributed to any of the areas.
Separate names with a comma.
Visiting from the US? Why not try DIYnot.US instead? Click here to continue to DIYnot.US.Dismiss Notice
